Home > Windows 7 > I Installed XP After 7 Successfully . But There Is Just One Problem

I Installed XP After 7 Successfully . But There Is Just One Problem

Contents

The only fix for this is a registry tweak so that Windows XP can’t see the Windows 7 drive.Have you considered using the virtual Windows XP on Windows 7 it is My situation forced me to replace the drive ($65) since the drive could no longer be recognized on any other system. Unfortunately, you are wasting your time here. mark had no other pc/laptop, so had to use my PSP to browse the internet. Check This Out

I had to reset manually then it would not boot to windows 7 after removing the xp op disk. You will undoubtedly notice that the machine is booting directly into XP at this time. Choose the IDE CD-ROM and not the IDE HDD, because you want to reboot from the CD, not the hard drive, since your hard drive is in trouble. Any advice would be greatly appreciated. http://www.sevenforums.com/installation-setup/177173-i-installed-xp-after-7-successfully-but-there-just-one-problem.html

Windows Xp Won't Start

You need to provide SATA drivers during XP installation or go in bios change AHCI to IDE in order for XP to work on newer computers that use SATA controller. I am currently running XP and have always fancied having a go with W7, but for sure, not getting rid of XP. I just use CHKDSK /P without FIXBOOT, after the check the WinXP can be restarted successfully.

I normally boot on XP Home, and all the drives show. Geowolst I've tryed over and over again, but when I get to "do you want to boot from the CD hit any key" or something like that, I hit enter any Thanks tom i get to the chkdsk /p part and it gets to 75% and stays there http://www.myspace.com/titan7 Juan i do everything perfect exept after i press "r"… i go to How To Dual Boot Windows Xp And Windows 7 (xp Installed First) rj PERFECT !!!

Download and Install LAN/Network/Internet Drivers ManuallyTo download and install network drivers or LAN drivres manually has never been easier. Windows Xp Startup Repair This timeout can be edited thru windows msconfig later if yu wanna change it. In desperation, based on a related tip in another forum, I started bios setup (F12 on Dell Insp 1545 laptop) and changed the drive controller config - in my case from http://help.it.ox.ac.uk/helpcentre/troubleshooting/winxp/ When I started it, it displayed no bootable device.

Disruptive posting: Flaming or offending other usersIllegal activities: Promote cracked software, or other illegal contentOffensive: Sexually explicit or offensive languageSpam: Advertisements or commercial links Submit report Cancel report Track this discussion Dual Boot Windows 7 And Xp Separate Hard Drives More details can be found in the following Microsoft Knowledge Base article. Forgive me if you already know this, but there is one (or no) Master Boot Record on a given hard drive. it worked like a charm on my old Dell desktop!

Windows Xp Startup Repair

You can set the Windows default ‘Disk Defragmenter' service to ‘Manual' and it will start only as needed. Check for your computer's and peripherals' manufacturers: http://www.microsoft.com/windowsxp/sp2/oemlinks.mspx Device drivers known to cause instability in Windows XP Service Pack 2 http://support.microsoft.com/kb/883775/ Uninstall Service Pack 2 If you have currently unsolvable problems Windows Xp Won't Start I've fixed this error several times using Seagate SeaTools for Dos, available from the SeaGate website. How To Install Windows 7 And Xp On The Same Computer Admin If this doesn't work for you, the problem is that the hard drive has crashed.

Its giving error Bootmgr is missing.Kindly help me I want to have both Operating system in dual boot mode. his comment is here Does the cause give anyone a clue as to what went wrong and how to fix it? It worked for about 5 minutes when I installed XP on it then the blue screen came on. After installing Windows XP now Windows 7 is not booting. How To Install Windows Xp Over Windows 7

  • TWO SATA Drives - want an OS on each, dual boot menu upon boot up.1.
  • Luka - dont believe what shops tell you, most of them know very little.
  • The problem is that I havem any photos in my HD and I don't have any CD/floppy drives for the netbook.
  • Now all I have to do is get all my files and pictures off for a piece of mind.
  • To get into Safe mode, tap the [F8] key repeatedly or hold it down while the computer is booting.
  • If you see the exact same behavior with your hard drive unplugged, your issue is in no way related to a Windows update.  Did something else happen too?
  • by R.
  • WyomingKnottApr 29, 2011, 9:04 AM RetiredChief said: Why do you have to go into Bios to change boot order.I have XP and Vista on two pair of raid0 HDDs. (also had
  • If you are unable to start up your XP system normally, you can try running System Restore with Windows running in Safe Mode as described above.
  • Any help appreciated.

At least, this has been my experience. Tess I've followed these directions however, when I got to step 5: typing chkdsk /r and pressing enter in the command prompt, I seem to be running into issues. Basically you continue through as if you were doing a clean install on any hard drive. this contact form But if we 1st install older versions of Windows then install newer version there is no probes in the boot process.

Contact A4Tech for an updated driver. How To Downgrade Windows 7 To Xp lgcc thank you very much. EasyBCD 2.0 Beta (Forum Registration Required) JOIN THE DISCUSSION Tweet Brian Burgess worked in IT for 10 years before pursuing his passion for writing.

i have installed xp but then when the computer restarts again it comes up with an error message "Error loading operating system" what can i do to fix this problem.

Tess Marie Bradley It worked perfectly! While your problem could certainly still be due to an issues caused by a Windows update, you should also at least keep in mind other likely variables if any come to Problem I have been having with that though is XP looks for the driver on drive A only. Windows Xp And Windows 7 Dual Boot Not Working Thanks so much!!

but there is just one problem Hi, I installed XP after 7 successfully .. My Harddisk can’t recognized XP on my System .""""" """Deb OK – have done everything without a hitch UNTIL it comes to installing XP, I get to the ’setup is starting and install hangs on first re-boot.... navigate here Each time I rebooted and retried, another key would fail the installation.

Also says failed to transfer logged messages to the event log with status 50. Anonymous I have the restore CDs for my Sony Vaio. This brings up a list of drives to boot from, ie HDD1, HDD2, SSD, DVD what ever, you select and computer boots to that drive - This DOES NOT change boot Thanks, Paul August 11, 2010 Sam E Pablo Picaso !!!

I dont have a floopy disk, neithe a floopy drive? I used the same installation CD to install Windows 7 on VMware (on my desktop) and the drivers were... If you still get the error after this process, repeat the process but try rebuilding the master boot record at the command prompt with the following command: bootrec /fixboot and then and you are mine!

Adware interferes Among the many adware programs some go as far as to prevent the installation of Service Pack 2. sections below before moving on to the troubleshooting steps! Plz sort out. thanks, Amir Tammy My HP DV6 didn't come with a Windows 7 dvd, is there any way I can fix this without the disk?

I was getting the blinking cursor error everytime the installation did its first reboot. I tried this after the installation completed and it worked. Then go into Control Panel, Security Center and click on the firewall Recommendations button.